6
7
www.deubaxxl.de
www.deubaxxl.de
ATTENTION!
Observe the safety and assembly
damaging the product.
use!
Important:
through at a later date. If you give the product to
anyone else at some point in the future, please
ensure you also pass on this manual.
Keep small parts out of the reach of children.
Check all elements and parts for damages.
Despite careful checks since may happen that
even the best product takes damage during the
transport. In this case, do not build up of your
health.
Never modify the product! Changes will void the
warranty and the product may be unsafe or even
dangerous.
For cleaning use a sponge and warm soapy water.
Do not use solvent based-cleaners or detergents
for example Bleach those can damage the
product.
Intended Use
The oil-extractor is the ideal equipment for quick
and clean oil-changes. The oil-extractor works
The oil is simply drawn out the motor through
•
•
Gearbox-oil (too viscous)
•
Danger of explosion!
•
Manufacturer will not assume any responsibility
in case of damages cause of an unappropriated
on its safety, cause danger and warranty will be
cancelled.
Please carefully read and observe the following
order to avoid environmental damages or injuries:
•
Oil pump operate only within the temperature
range of 40 - 50°C.
•
•
in use - hold the machine securely.
•
A slipping of the oil pump leads inevitably to
ready for wiping.
•
Make sure that your car is not parked on a
be possible. Make sure that the parking brake
is engaged.
INSTRUCTIONS
•
•
Do not pump hot oil or when the car engine is
running.
•
•
•
goods or fuels. Danger of explosion.
•
Do not pump water.
•
Oil pump is not suitable for storage and/or
•
•
not use any force, but do it in gently manner.
•
Take special care when using oil pump and
•
Only operate when engine oil is warm. Hot oil
can melt the hose.
•
The oil pump should never be operated without
motor will be overloaded.
The oil-extractor is a vane-pump with brass-
lamellas. It is driven by a 12V-D.C.-motor via a
pump are built for hoses of 10 mm internal
probe is 6 mm. Therefore the pump can only
be used for oil-change if the inner diameter of
extractor is suitable to pump engine-, diesel- and
OPERATION
•
socket (5).(Fig. 2)
•
Push the drain hose (8) onto the drain tube
socket (6).
•
Fasten both hoses using the included hose
clamps (9).
•
Ensure the two hoses are not bended or kinked.
•
Insert the pumping well into the oil-gauge hole
down to the deepest point of the engine sump.
•
Put the outlet hose into a suitable container.
•
•
Switch the oil pump on.
•
pump. Do net let the pump running idle.
Notes:
•
lamellas inside the pump are probably not
directly into the nozzle (without hose).
•
Note that you do not exceed the maximum heel
height of 70 cm.
Storage and Care:
Remove the hoses from the pump, plug them
together and Store the whole unit in a place,
where it is protected against dust.
any maintenance or checks.
Check all parts for signs of wear. If any problems
are detected, do not use the product. Always
replace all parts with original replacements
according to the manufacturer's guidelines.
