Attaching the microfiber cleaning pad
Take care:
Ensure yourself that the device has been disconnected from the power supply.
Attach the microfiber cleaning pad. Tighten the drawstring.
Starting the device
Take care:
Always use the device with the microfiber cleaning pad attached to the foot
.
Take care:
prior to putting the device into operation, always check whether a surface or material is
actually suitable for treatment with steam. Do this by executing a test on a hidden spot of the
material you wish to treat. If you doubt whether the material that is to be treated is suitable for
steam, please contact the manufacturer or supplier of the material.
Take care:
Do not keep the device too long on one spot! This can cause damage to materials!
Take care:
do not let the device heat up on a painted or wooden surface! Let the device heat up
while you keep it above the floor, until the green indication light goes on which indicates that the
device is ready for use.
1.
Unwind the power cable in its entire length.
2.
The device can leak water while heating up. Before use, place an old absorbent cloth under
the device so as not to damage the floor.
3.
Insert the plug into the socket. The device activates automatically and begins heating up.
The orange indication light lights up. Do not use the device until the green indication light
lights up too.
4.
After 30 seconds, the green indication light lights up. The device is ready for use. The
orange indication light remains on during use, while the green indication light will switch on
and off repeatedly during use as to maintain temperature.
5.
Put pressure on the foot and move the handle down to get the device into operating
position.
6.
Press the steam release trigger and steam will be emitted. Move the device slowly over the
surface that is to be treated, while holding the steam release trigger.
7.
The device has a swivel foot. When you turn the handle left or right, the foot moves
sideward, which makes it possible to clean places that are hard to reach.
Use of dispenser
The device is fitted with a dispenser to give the steam a maximum sanitizing power. The
cleansing agent supply can be turned on or off.
Take care:
Cover or remove food when you are cleaning areas where food is. Do not use cleansing
agent for cleaning surfaces that come into direct contact with food. In this case, put the cleansing
agent switch to ‘close’.
1.
Make sure that the dispenser is filled with liquid cleansing agent.
20
