Page 28
XG0508-
150204.1
I-Series Indoor Gas Fireplace
Installation
7). Slip the Split Plastic Grommet, found in the plastic bag attached
to the master override switch, around the Power Cable and then
press it into the provision on the right lower side of the Rear
Faceplate to secure the Power Cord.
Figure 54 Sec.4
8). Thread the On/Off Wire Harness through the gap between the
Control Board Mounting Bracket and the Rear Faceplate Panel.
Figure 55 Sec.4
9) Connect the Plug to the appropriate terminal on the Control Panel.
Figure 56 Sec.4
10). Place the Zip Strap through the hole in the Plastic Stick on
Retainer on the back of the Rear Faceplate. Zip the wires together
in one tidy package as shown.
Figure 57 Sec.4
6). Remove the twist tie and Zip Strap that is on the On / Off
Switch wire harness.
Figure 58 Sec.4
