Page 50
XG0508-
150204.1
I-Series Indoor Gas Fireplace
Maintenance
Burner Installation / Removal
Your new fireplace is shipped with the burner already in position.
Periodically, the burner needs to be cleaned and inspected or
perhaps if the pilot needs service or the unit is to be converted
to LP, you will need to remove and/or re-install the burner. The
burner is mounted to the fireplace in 3 places. At the rear of the
burner is the Mixing Tube. At the front are two small tabs which
fit through a slot and are simply bent to keep the Burner secure.
** The Burner is a cast ceramic material. It is easily chipped or
scratched. Take care when handling, removing or re-installing the
burner not to damage it. **
** When installing or removing the Burner, take due care not to damage
the Pilot Assembly. The Burner has to be lifted over the Pilot in either
case and contact with the Pilot should be avoided **
Burner Support Bracket
Figure 26 Sec.10
Burner support bracket location
Mixing Tube
Figure 27 Sec.10
Log burner mixing tube
Figure 28 Sec.10
1)
.
Using a small screw driver or pliers, bend the tabs straight so
that they will fit through the slots when the burner is removed.
Figure 29 Sec.10
2)
. By grasping the burner at either side (if the Firebox Panels
are both removed) or at the front and rear, first lift the front of the
Burner up about 1-2 inches. Then pull the Burner towards you to
remove the Mixing Tube from the Rear Burner Support. Lift the
Burner out of the Firebox and store is a place where it won’t get
damaged.
Front Burner Supports
Burner Removal
