10
11
1
•
888
•
557
•
3848
Wards.com
Operating Instructions
(cont’d)
Bobbin Winding
1. Pull the handwheel (1) out.
2. Draw the thread from the spool
and guide the thread around the
bobbin winder thread guide (2).
3. Insert the thread through the hole
in the bobbin (3) from the inside to
the outside. Put the bobbin on the
bobbin winder spindle.
4. Push it to the right.
5. With the free end of the thread
held in your hand, depress the
foot control. Stop the machine
when it has made a few turns and
cut the thread (5) close to the hole
in the bobbin.
6. Depress the foot control again.
When the bobbin (6) is fully
wound, stop the machine. Return
the bobbin winder spindle to its
original position by moving the
spindle to the left, and cut the
thread.
7. Push the handwheel (7) back into
the original position.
Note:
Return the bobbin winder
spindle when the machine stops.
Operating Instructions
(cont’d)
Bobbin Case Threading
Place the bobbin into the
bobbin case. Make sure
the thread unwinds in the
direction of arrow
.
Pull the thread into
the bobbin case
slot.
Draw the thread under
the tension spring and
into the delivery
eye,
leaving about 4
"
of
free thread.
Threading the Machine
First, raise the take-up lever to its highest position by turning the handwheel toward
you. Next, raise the presser foot. Then place a spool on the spool pin as shown,
with thread coming from back of the spool.
1. Draw the thread into
thread guide (1) using
both hands.
2. While holding the
thread near spool,
draw thread down into
the tension area and
then around the check
spring holder (2).
3. Firmly draw the thread
up and through the
take-up lever (3) from
right to left.
4. Then draw the thread
down and slip it into
needle bar thread
guide (4) on the left.
5. Thread the needle eye
(5) from front to back.
