Montesa COTA 4RT 260 2020, Owner'S Manual

Page: 135 / 158

(1) SHOCK ABSORBER LOWER MOUNTING BOLT/NUT
(2) SHOCK ARM PLATES-TO-SWINGARM BOLT/NUT
Swingarm
Removal
Remove the following:
– Rear wheel (page 5-15)
– Shock absorber lower mounting bolt/nut
– Cushion arm plates-to-swingarm bolt/nut
(1) CUSHION LINK
(2) CUSHION ARM PLATES
(3) BOLTS/NUTS
(4) LOWER MOUNTING BOLT/NUT
Installation
Install the following:
– Cushion link
– Cushion link-to-frame socket bolt/nut
– Cushion arm plates
– Cushion arm plates-to-swingarm bolt/nut
– Cushion arm plate-to-cushion link bolt/nut
– Rear cushion lower mounting bolt/nut
Tighten the cushion arm plate and cushion link nuts to the
specified torque.
Torque: 39 N•m (4.0 kgf•m, 29 lbf•ft)
Tighten the rear cushion lower mounting nut to the
specified torque.
Torque: 39 N•m (4.0 kgf•m, 29 lbf•ft)
(1) PIVOT COLLAR A
(2) PIVOT COLLAR B
(3) DUST SEALS
(4) NEEDLE BEARINGS
Needle Bearing Replacement
Remove the pivot collars and dust seals.
Check the cushion link needle bearings for damage.
Remove the cushion link needle bearings using the special
tool.
Tool:
Bearing driver 07946-MJ0A100
Press new needle bearings into the cushion link to 3 mm
(0.12 in) below the surface of the cushion link using the
special tool, on both sides.
Face the bearing with its marked side facing out.
Tool:
Bearing driver 07946-MJ0A100
Apply multi-purpose grease to the collars and dust seal
lips.
Install the dust seals and pivot collars.
5-20 5-20
Frame servicing
4
4
3
3
2
1
1
2
2
3
4
2
1
3 mm
(0.12 in)
3
3