Montana 100, Operator'S Manual

Page: 12 / 26

13
7. Install the safety pin and clip, 1, in the loader
arm lock pin, 2.
8. Start the engine on the tractor and activate
the loader control lever to raise the lift cylinder.
Lower the bucket, 1, in the extended; dump
position, with bucket cutting edge, 2, resting on
the ground. Stop the engine on the tractor and
set the parking brake.
WARNING
Never attempt to fold the loader support leg
unless the bucket is resting on the ground.
9. Remove the pins and clips, A and B, from the
loader support leg. Fold the loader support leg,
C, and place into the stored position. Install the
pins and clips, A and B, to secure the loader
support leg.
10. Start the engine on the tractor and activate
the loader control lever. If the loader does not
operate normally, as shown on the control decal,
check the quick couplers for proper connections.
WARNING
Do not attempt to operate the loader without
the loader arm lock pins in place and
secured. The loader can fall off of the
tractor.