MONTAGUE M-E1, Owner'S Manual

Page: 26 / 69

26
Your new e-bike was assembled and
tuned in the factory and then partially
disassembled for shipping. You may
have purchased the e-bike already
fully assembled and ready to ride OR
in the shipping carton in the partially
disassembled form.
If you have questions or concerns about
any of these steps, please see a bicycle
dealer or contact Montague’s Customer
Support Team at +1 617-491-7200.
Carefully follow the Final Assembly
Instructions attached to your bike. Once
you have completed the assembly, read
the remainder of this Owner’s Manual.
Packing List
Inside your box you will find:
• 1 Mostly Assembled Bicycle
• 1 Front Wheel
• 1 Saddle with seat post
• 1 Small Parts Box which includes:
• 1 15 mm Pedal Wrench
• 1 Hex wrench
• 1 10 mm open end wrench
• 1 Front wheel quick release
• 1 Steering damper spring
• 1 Battery (some models)
• 2 Keys for battery (some models)
Carefully remove the e-bike and all ac-
cessories from the box to avoid scratch-
ing the frame. Check the carton for loose
parts before discarding.
Assembly
Note: Depending on the model year and
design, your e-bike may be assembled
differently. Refer to the Final Assembly
Instructions attached to your bike for the
most up to date information.
For additional manuals, please visit
montaguebikes.com/online-owners-
manual/.
Installing Front Wheel Quick
Release
The front wheel quick release skewer
is shipped separately and can be found
in the small parts box. To install it in the
front wheel:
1. Remove the quick release
adjustment nut by rotating it counter-
clockwise to loosen. Remove the first
spring next to the adjustment nut,
and set both pieces aside (Fig. 7).
2. Slide the quick release skewer into
the hollow axle of the front wheel
hub, with the quick release lever
located on the side opposite the disc
brake rotor. The lever being on the
correct side is important to ensure
the bike can fold completely.
3. The end of the skewer should stick
out from the opposite side of the hub.
Slide the spring that was removed
in step 1 back onto the end of the
skewer, and thread the end nut back
onto the skewer, turning it clockwise.
You can see the layout and order of
parts in Fig. 7 on the opposite page.
ASSEMBLING YOUR MONTAGUE BICYCLE
Never attempt to ride a bicycle that is
not properly assembled.
WARNING