MONTAGUE FB-108-R, Instruction Manual

Page: 17 / 33

SERVICE
Once you have removed the screws from the
condensing unit base, the condensing unit will
retract from the condenser cabinet on a sliding
shelf.
There is an additional removable right side panel
for condensing unit accessibility if the installation
of the unit will allow.
Lift panel up and pull the bottom of the panel out
to remove.
REPLACING SNAP– IN GASKETS
Drawer gaskets are critical to maintaining the set
temperature of your unit and should create a
flush seal when the drawers are closed .
Defective gaskets can cause icing, inconsistent
temperatures,
food contamination, and
inefficient operation of your compressor.
To Replace:
1. Pull drawer open until it stops, pull back on
slide locks on left and right side retractable
slides ,lift drawer slightly while pulling back
until drawer assembly is removed.
2. Remove gasket by pulling (by hand) from
retaining strip.
12