16
3.3.2 INSTALL KING PIN END CAPS
Prevent death or serious injury.
Center frame assembly weighs approximately 750 lbs (340 kg).
King pin end cap weighs approximately
100 lbs (45 kg).
Use adequate lifting and support devices.
1.
Raise and support center frame using adequate lifting and
support devices capable of supporting up to 10,000 lbs
(4536 kg) total assembly weight.
2.
Install end cap (A) to center frame (B) or optional axle
spacer with ¾-10 x 2½ inch bolts and ¾ inch lock nuts.
Tighten bolts to 317 lb/ft (430 Nm) of torque.
3.
Repeat step 2 for other side.
3.3.3 INSTALL SPINDLE ASSEMBLIES
Prevent death or serious injury.
Spindle assembly weighs approximately
360 lbs (163 kg).
Use adequate lifting and support devices.
1.
Raise and position spindle assembly (A) on king pin end
cap.
Note: Tie-rod mounting bracket (B) faces forward. Pins are
inserted from bottom (nut on top) to permit pin removal without
removal of fertilizer tank skid.
2.
Insert spindle pin from bottom through lower spindle assembly bracket. Bearing (C) must be between spindle assembly
and king pin end cap as shown.
3.
Install lock nut (D) on spindle pin. Tighten as securely as possible without bending plates.
4.
Repeat Steps 1-3 for other side.
A
B
A
B
C
D