MONSTERMOUNT MB-1003, Installation Instructions Manual

Page: 4 / 16

ENG
4
Mounting to the Wall (Concrete)
IMPORTANT! For safety reasons, the concrete wall must be capable of sup-
porting the combined weight of the mount and the display. The manufacturer
takes no responsibility for failure caused by walls of insufficient strength.
1. Place the wall plate against the wall in the desired location. Make sure it is
level.
2. Mark the two locations for securing the wall plate (see Fig. 3) and set the wall
plate aside.
3. Drill an 8 mm (5/16”) hole at each marked location. Remove any excess dust
from the holes.
4. Insert a concrete anchor (B) into each hole so that it is flush with the concrete
surface (see Fig. 4). A hammer can be used to lightly tap the anchors into place
if necessary.
NOTE: If the concrete wall is covered by a layer of plaster or drywall, the con-
crete anchor must pass completely through the layer to rest flush with the
concrete surface.
5. Place the wall plate back against the wall and attach it using the drywall
screws (A) provided.
Do not over-tighten these screws. Ensure that the wall
plate remains level after both screws are secured.
STEP 1B
Fig. 3
Fig. 4