16
This screen allows you to change the network settings of the
Encoder.
•
DHCP: When set to ON, the Encoder will automatically
obtain its IP address, Subnet, and Gateway. When set to
OFF, you can change the network settings. The IP address
and the Gateway must use the same network segment,
with the first three numbers in the address having the
same value and the last number should be different. Click
the Status button to display the network settings in the
Status Log.
•
Addresses: If DHCP is set to OFF, you can input an IP
address, Subnet mask, and Gateway. The first three
numbers of the IP address and Gateway must be the same,
with the last number different. Note that if you change the
IP address, you can continue using the current connection,
but when you reconnect later, you must use the new IP
address. Click the Set button to save the new address
settings. The default IP address is 192.168.10.10, the default
Subnet mask is 255.255.255.0, and the default Gateway is
192.168.10.1.
•
port: Input the desired net port, then click the Set button
to save the value. The default port is 80.
