6
49-80329 Rev. 5
Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
REMOVE THE PACKAGING
CAUTION
LIFT THE HOOD OUT OF THE BOX
BY THE CENTER METAL PORTION. DO NOT LIFT BY
THE GLASS SIDES.
CAUTION
Wear gloves to protect against
sharp edges.
■ Grasp the hood by the metal insert in the center and
lift straight up and out of the box.
■ Remove and properly discard the plastic wrapping.
■ Remove parts box, duct covers and other packaging.
Pencil and tape measure
Pliers
120V 60Hz. 15 or 20 Amp,
2-wire with ground. properly
grounded branch circuit.
Key hole saw
Wire cutter/stripper
Step ladder
Metal snips
Saber saw
or sawsall
Wire nuts
Phillips and
flat blade
screwdrivers
Strain relief for
junction cover.
Spirit level
Flashlight
Safety glasses
8" round metal
duct, length to
suit installation.
Duct tape
3/8" swivel
socket or pivoting
hex socket with 6"
extensions
Carpenter’s square
Hammer
Electric or battery-operated drill
and 3/16" bits, Phillips and flat
blade screwdriver bits.
1” = 2.5 cm; 1’ = 0.3 m
