2
49-80329 Rev. 5
Safety Information
READ AND SAVE THESE INSTRUCTIONS
BEFORE YOU BEGIN
Read these instructions completely and carefully.
■
IMPORTANT
—
Save these instructions
for local inspector’s use.
■
IMPORTANT
— Observe all governing
codes and ordinances.
■
Note to Installer
— Be sure to leave these
instructions with the Consumer.
■
Note to Consumer
— Keep these instructions with
your Owner’s Manual for future reference.
■
Skill Level
— Installation of this appliance requires
basic mechanical and electrical skills.
■
Completion Time
— 1 to 3 Hours.
■ Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the warranty.
■ For Monogram local service in your area, visit
monogram.com
.
■ For Monogram service in Canada, visit
monogram.ca
■ For Monogram Parts and Accessories, visit
monogram.com/use-and-care/parts.
CAUTION
Due to the weight and size of these
vent hoods and to reduce the risk of personal injury
or damage to the product,
TWO PEOPLE ARE
REQUIRED FOR PROPER INSTALLATION.
WARNING
To reduce the risk of fire or electrical
shock, do not use this range hood with any external
solid-state speed control device. Any such alteration
from original factory wiring could result in damage to
the unit and/or create an electrical safety hazard.
TO REDUCE THE RISK OF FIRE, USE ONLY
METAL DUCTWORK.
WARNING
TO REDUCE THE RISK OF FIRE,
ELECTRICAL SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended by the
manufacturer. If you have any questions, contact
the manufacturer.
B. Before servicing or cleaning the unit, switch the
power off at the service panel and lock the service
disconnecting means to prevent the power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
■ For general ventilating use only. Do not use to exhaust
hazardous or explosive materials or vapors.
■ Structural framing, installation work and electrical
wiring must be done by qualified person(s) in
accordance with all applicable codes and standards
including fire-rated construction.
■ Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back drafting. Follow
the heating equipment manufacturer’s guidelines
and safety standards such as those published by
the National Fire Protection Association (NFPA), and
the American Society for Heating, Refrigeration and
Air Conditioning Engineers (ASHRAE), and the local
code authorities. When applicable, install any makeup
(replacement) air system in accordance with local
building code requirements. Visit GEAppliances.com
for available makeup air solutions.
■ Local codes vary. Installation of electrical connections
and grounding must comply with applicable codes.
In the absence of local codes, the vent should be
installed in accordance with National Electrical Code
ANSI/NFPA 70-1990 or latest edition.
CAUTION
To reduce risk of fire and to properly
exhaust air, be sure to duct air outside — do not vent
exhaust air into spaces within walls or ceilings or into
attics, crawl spaces or garages.
