5
Monessen • Mojo Installation/Owner’s Manual • 4623-900 Rev. D • 04/21
2
Getting Started
A. Design and Installation Considerations
Installation MUST comply with local, regional, state and
national codes and regulations. Consult insurance carrier,
local building inspector, fire officials or authorities having
jurisdiction over restrictions, installation inspection and
permits.
Before installing, determine the following:
•
Where burner assembly and log set are to be installed.
•
Gas supply piping.
•
Whether optional accessories—devices such as a wall
switch or remote control—are desired.
•
Approved wood burning masonry fireplace or vent-
free firebox.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
service technician, service agency or your dealer.
C. Inspect Appliance and Components
• Carefully remove the appliance and components from
the packaging.
• Report to your dealer any parts damaged in shipment.
•
Read all of the instructions before starting the instal-
lation. Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
NOTE:
Logs are packaged and sold separately.
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
•
Tape measure
•
Gloves
•
Voltmeter
•
Manometer
•
Phillips screwdriver
•
Safety glasses
•
Flat blade screwdriver
•
Soapy water solution for gas leak testing
•
Electric drill and bits (1/4 in. magnetic)
•
External regulator (for propane/LPG only & 1/2 psi
Natural gas system
•
Piping which complies with local codes
•
Pipe sealant approved for use with propane/LPG
(Resistant to sulfur compounds)
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
WARNING! Risk of Fire, Explosion or Electric Shock!
DO NOT
use this appliance if any part has been under
water. Call a qualified service technician to inspect the
appliance and to replace any part of the control system
and/or gas control which has been under water.
•
Manual shutoff valve
•
Sediment trap
• Tee joint
•
Pipe wrench
•
5/32" drill bit
WARNING! Risk of Fire or Explosion!
Damaged parts
could impair safe operation.
DO NOT i
nstall damaged, in-
complete or substitute components. Keep appliance dry.
CAUTION
Installation and service of this appliance should be performed by
qualified personnel. Hearth & Home Technologies recommends
HHT Factory Trained or NFI certified professionals.
Gloves are recommended when handling
refractory logs to prevent skin irritation
from loose fibers. Logs are fragile; handle
with care.