3
Monessen • Mojo Installation/Owner’s Manual • 4623-900 Rev. D • 04/21
Installation Standard Work Checklist
Customer:
Lot/Address:
Model
(circle one):
MJ22
NIF/PIF
, MJ27
NIF/PIF
Date Installed:
Location of Fireplace:
Installer:
Dealer/Distributor Phone
#
Serial #:
Comments:
Further description of the issues, who is responsible (Installer/ Builder/ Other Trades, etc) and corrective
action needed _____________________________________________________________________________________
Comments Communicated to party responsible ____________________ by ______________________on ___________
(Builder / Gen. Contractor/) (Installer)
(Date)
?
Y
H
W
,
O
N
F
I
S
E
Y
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
4
623
-9
82B
1/20
= Contains updated information.
• Photographing the installation and copying this checklist for your file.
• That this checklist remain visible at all times on the appliance until the installation is complete.
This standard work checklist is to be used by the installer in conjunction with, not instead of, the instructions contained in this
installation manual.
WARNING! Risk of Fire or Explosion!
Failure to install appliance according to these instructions could
lead to a fire or explosion.
ATTENTION INSTALLER:
Follow this Standard Work Checklist
Gas Log
Install Sections
2
and
6
(Pg.
5
&
20
)
Verified that the
chimney has been cleaned
.
(pg. 13)
Verified
clearances to combustibles.
Gas Logs are leveled and secured.
See
page 8 for adequate provisions for combustion and ventilation
air have been verified.
Gas Section
4
(Pg 1
5
)
Proper appliance for fuel type.
Leak check performed and inlet pressure
verified.
Verified proper air shutter setting for installation type.
Electrical
Section
5
(Pg
17
-19
)
Switch wires properly installed.
Embers & Logs
Section
6
(Pg
20-23
)
All packaging and protective materials removed (inside & outside of
appliance).
Embers and logs
installed correctly.
Accessories installed properly.
Finishing Section 3
(Pg
9
)
Verifi ed all clearances meet installation manual requirements.
Mantels and wall projections comply with installation manual requirements.
Manual bag and all of its contents are removed
and the log set
given to party responsible for use and operation.
Started
log set
and veri
fi
ed no
gas leaks exist.
Hearth & Home Technologies recommends the following: