19
Monessen • Mojo Installation/Owner’s Manual • 4623-900 Rev. D • 04/21
Control Module Operation
1. The control module has an ON/OFF/REMOTE selector
switch that must be set. See Figure 5.3.
OFF Position: Appliance will ignore all power inputs and
will not respond to any commands from a wall switch or
remote. The unit should be in the OFF position during
installation, service, battery installation, fuel conversion,
and in the event that the control goes into LOCK-OUT
mode as a result of an error code.
ON Position: Appliance will ignite and run continuously
in the HI flame setting, with no adjustment in flame
output. This mode of operation is primarily used for
initial installation.
REMOTE Position: Appliance will initiate commands
from an optional wired wall switch and/or the wireless
remote (RC300).
2. If using a wired wall switch with the module in REMOTE
mode, the appliance will ignite and run continuously in
the HI flame setting, with no adjustment in flame output.
3. The control module has safety feature that automatically
shuts down the heater after 9 hours of continuous
operation without receiving a command from the RC300
remote.
4. If you intend to use both an optional wired wall switch
and the RC300 remote control to operate your fireplace,
the wall switch will override any commands given by
the remote.
5. Battery life will be shortened if the flame adjustment
feature is used frequently on the RC300 remote control.
6.
Module Reset
This module may lock-out under certain conditions.
When this occurs, the appliance will not ignite or
respond to commands. The module will go into
lock-out mode by emitting three audible beeps, then
continuously displaying a RED/GREEN error code at
its status indicator LED.
• Locate the module selector switch. (See Figure 5.3).
• Set the module selector switch to the OFF position.
• Wait five (5) minutes to allow possible accumulated gas
to clear.
• Set the module selector switch to ON or REMOTE
position.
• Start the appliance.
WARNING! Risk of Explosion! DO NOT
press the mod-
ule reset switch more than one time within a five min
-
ute time period. Gas could accumulate in firebox. Call a
qualified service technician.
Nine Hour Safety Shutdown Feature
The appliance has a safety feature that automatically
shuts down the heater after nine hours of continuous
operation without receiving a command from the wall
switch or optional remote.
Appliance ON/OFF
Use the IntelliFire® Plus with ODS Remote Control to
control the ON/OFF function of the appliance. Follow
instructions included with the remote control. If desired,
a wall switch may be installed to control the ON/OFF
function of the appliance.
C. Detailed Component Operating Instruc-
tions— IntelliFire® Plus with ODS (Bat-
tery Only)
Figure 5.3 Control Module
MODULE
NG/LP GAS-TYPE
SELECTOR SWITCH
STATUS
INDICATOR LED
SELECTOR SWITCH