Monessen • Mojo Installation/Owner’s Manual • 4623-900 Rev. D • 04/21
20
6
Gas Log Sets
Figure 6.1 - Installing Rock Wool
• Gloves are recommended when handling logs to
prevent skin irritation from loose fibers. Logs
are fragile - handle with care.
• Use only rock wool provided with log set.
• DO NOT ADD ADDITIONAL ROCK WOOL.
WARNING
BEFORE YOU BEGIN
Mojo logs are sold separately. Do not handle these logs
with your bare hands.
Always wear gloves to prevent
skin irritation from refractory material.
After handling
the logs, wash your hands gently with soap and water to
remove any traces of refractory material.
The positioning of the logs is critical to the safe and
clean operation of this heater. Sooting and other
problems may result if the logs are not properly
and firmly positioned in the appliance. Never add
additional logs or embellishments such as pine
cones, vermiculite or rock wool to the heater. Only
use rock wool supplied with the unit.
Failure to position the parts in accordance with
diagrams below or to use only parts specifically
approved for this heater may result in property
damage or personal injury.
WARNING
A. PLACE ROCK WOOL
Before installing logs, place rockwool in dime size pieces
evenly over small burner ports starting in front of the rear
deflector shield towards the front. Avoid placing rock wool
over the slots on rear and right side of burner and on large
yellow flame ports on front of burner.
Wash hands after placing rock wool. Itching may occur.
FP2011
place rock wool
Dime-Sized
Pieces of Rock
Wool
Figure 6.2 - Correct Rock Wool Placement
NOTE
— This unit requires the use of ceramic fiber logs.
Do not handle these logs with your bare hands.
Always
wear gloves to prevent skin irritation from refractory
material.
After handling the logs, wash your hands gently
with soap and water to remove any traces of fibers.