6
26D3311
26D3311
7
GETTING STARTED
MAKE SURE YOU HAVE RECEIVED ALL PARTS
Check your packing list to verify that all listed parts have been received. You should have the following:
• Installation/Operating instructions
•
Brass Louvers (5)
• 33" unvented gas heater with simulated brick panels.
•
Canopy
• Plastic bag containing crushed volcanic rock
•
Two (2) anchoring screws
• Mounting screws for canopy
•
Remote Control (Hi/Lo Model Only)
• Log box contains a four (4) piece log set, refer to installation instructions
Accessory face plates available to finish the insert.
• DIFACESM Black small face 33"H x 43"W
•
DIFACELG
Black large face 36"H x 50"W
• JADE
Jade simulated marble small face 33"H x 43"H
Accessories include brass trim and mounting hardware
The milli-volt controlled version of this heater is the only style designed to be operated with optional devices for
ON/OFF functions. The following options may be used with the milli-volt controlled heater. These options are not
packaged with the log set.
• Hand held Remote with Receiver
• Wall switch with 15' wire.
• Wall T-stat with 15' wire.
• Hand held Thermostat Remote with Receiver
• Thermostat Sensor
• Handle the gas log burner assembly by the grate only. Do not pick the unit up
by the burners.
• Gloves are recommended when handling ceramic fiber logs to prevent skin irritation
from loose fibers. Logs are fragile — handle with care.
W
ARNING
Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately inform the
dealer from whom you purchased the appliance.
Do not attempt to install any part of the appliance unless you
have all parts in good condition.
WHAT YOU WILL NEED FOR INSTALLATION
You must have the following items available before proceeding with installation…
• External regulator (for propane / L.P.G. and 1/2 lb. Natural Gas Systems only)
• Piping which complies with local codes
• Sediment trap
• Tee joint
• Pipe wrench or appropriate size crescent wrench set
• Phillips head screwdriver
• Drill with 5/32" bit
• Optional face plate kit.
• Manual shutoff valve
• Optional trim kit for installation into wall or free standing Mantle without three piece faceplate
• Pipe sealant approved for use with propane / LP.G (Resistant to sulfur compounds)
