22
26D3311
26D3311
23
LOG PLACEMENT
PLACING THE DECORATIVE ROCK
Figure 27 - Installing Logs
to Grate
Before you begin
— This unit is supplied with four ceramic fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling the logs, wash your hands gently
with soap and water to remove any traces of fibers.
Log #2 Log #4
Log #1
Log
#3
Back
Pins
Front
Pins
DO NOT sprinkle volcanic rock on the logs or around the pilot or the main burner. This
may cause sooting. Place volcanic rock only on the floor of the fireplace.
During initial operation of the new heater, burning logs will give off a paper burning
smell and orange flames will be present. Simply open the windows for a few hours
to vent the odor.
W
ARNING
The positioning of the logs are critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly positioned
in the appliance. Never add additional logs or embellishments such as pine cones,
vermiculite or rock wool to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifically approved for this heater may result in property damage or personal
injury.
W
ARNING
INSTALLING LOGS ON GRATE
(See Figure22)
1. Install back log (#1) on two pins located near the back of base.
Check log position and stability.
2. Install center log (#2) on two pins located near the front of
the base.
3. Install middle front log (#3) in front of center log. Make sure
bottom of log is resting on the base of the center prong of
grate.
4. Place back end of top center log (#4) on recessed area of back
log (#1). Cross log #4 over log #2 and rest right extension
on grate.
