RED GLOWING EMBERS
RED GLOWING EMBERS
1. LOOK DOWN BETWWEN THE LOGS TO SEE THE BURNER.
1. LOOK DOWN BETWWEN THE LOGS TO SEE THE BURNER.
THE FLAMES SHOULD BE STABLE ON THE BURNER.
THE FLAMES SHOULD BE STABLE ON THE BURNER.
2. THE FLAMES SHOULD BE BLUE AT THE BURNER AND
2. THE FLAMES SHOULD BE BLUE AT THE BURNER AND
YELLOW AT THE TOP.
YELLOW AT THE TOP.
3. INSURE THAT THE PILOT FLAME IS STABLE AND
3. INSURE THAT THE PILOT FLAME IS STABLE AND
CONTACTING THE THERMOPILE.
CONTACTING THE THERMOPILE.
YELLOW TIPPED FLAMES
YELLOW TIPPED FLAMES
LOW MASS
LOW MASS
THERMOCOUPLE
THERMOCOUPLE
THERMOCOUPLE
THERMOCOUPLE
PILOT
PILOT
16
5. Insure that the flow of combustion and ventilation air is not obstructed.
6. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control system and any gas control which has been under
water.
7. This appliance must only be operated with glass door model number GD36PB or model number GD36B
properly installed per the Fireplace Setup instruction section of this manual. If the door is damaged or broken,
it may only be replaced by a complete assembly as supplied by the manufacturer. See the Repair Parts List.
8. Never attempt to replace the glass panel with another piece of glass or use any other substitute materials.
9. Never attempt to operate this appliance with a broken glass door.
10. When removing or replacing the glass door for cleaning or inspection, care must be taken not to abuse the
glass panel by striking, slamming shut, or scratching against other surfaces.
11. Only trim kits and other optional accessories supplied by the manufacturer may be used with this appliance.
Draft relief openings must never be covered or blocked.
12. Cleaning the glass - Wear gloves while handling the glass door assembly. DO NOT REMOVE GLASS DOOR
WHEN HOT. Handle the glass door with care to avoid striking or scratching the glass. Clean the inside and
outside surfaces of the glass panel using a mild detergent and water solution with a soft cloth. Do not use
abrasive cleansers which might scratch the glass surface. Do not attempt to clean the glass when the surface
is hot. The glass door must be properly reinstalled after cleaning. Do not operate this appliance without the
glass door properly in place.
13. Service - Any service to the burner/gas control system or electrical system and its components, must only be
performed by a qualified service technician.
M
AINTENANCE
I
NSTRUCTIONS
F
IGURE
8
53D9015. Rev 1 03/03
Summary of Contents for BBV400NE
Page 21: ...NOTES 21 53D9015 Rev 1 03 03 ...
Page 22: ...22 NOTES 53D9015 Rev 1 03 03 ...
Page 23: ...NOTES 23 53D9015 Rev 1 03 03 ...
