Monarch Water ULTIMATE PREMIO HE, Install Manual

Page: 8 / 21

/ O. SET WATER HARDNESS
• Wait until display changes to Hardness.
• Use Up/Down buttons to set number as determined by your water hardness test.
• Press to confirm setting.
• You have finished the programming.
• The display will now automatically revert back to the alternating display. After 30 seconds the
display will go to sleep. This helps prolong the life of the battery.
• If at any time you want to reset a figure, press the up or down arrow to turn the display back on.
Then wait until the display changes to the relevant setting and then reprogramme as required.
/ P. FLUSH SOFTENER - IMPORTANT
• For Ultra HE and Premio HE add 4 litres of water upon initial installation. Place Rapid-Fit bypass in
Service position by pushing plunger as per directional arrow - see Fig 4 previous page.
• Check for leaks.
• Leave a soft mains tap e.g. bathroom wash hand basin, to run for a minimum of 5 minutes to purge
any air and ‘resin dust’ from the softener (resin dust may appear orange in colour).
• Please ensure the unit is kept full of salt. The Ultra HE can use either tablets or blocks. The Premio
HE must use tablets only. When using tablet salt, please do not fill salt compartment 100% full,
kindly leave a gap of 30mm between the top of the salt and the front of the salt compartment -
please use the image opposite for guidance.
• If at any time you see excess water in the salt compartment going down the overflow, please call
our service department on +44 (0) 1986 784759 (opt 2).
8
FILL LEVEL
/ SALT FILL LEVEL