6
English
ANT
UB-900i
OUTPUT
ANT
UB-900i
OUTPUT
Deutsch
Deutsch Seite
Français
Français Page
Italiano
Italiano Pagina
Español
Español Página
Nederlands
Nederlands Pagina
Polski
Polski Strona
Dansk
Dansk Sida
Svenska
Svenska Sidan
Suomi
Suomi Sivulta
English
English Page
Antenna
input
Increasing the gain
with two UB-900I
Antenna Signal Amplifier
These instructions are intended for users without
any specific technical knowledge Please read the
instructions carefully prior to operation and keep
them for later reference
1 Overview
ANT
UB-900i
OUTPUT
1
2
3
4
5
6
1
Power indicator
2
BNC jack OUTPUT to route the amplified an-
tenna signal to the receiver
3
16 mm (
3
∕
5
”) threaded hole to attach the mount-
ing bracket (5) or a microphone stand
4
BNC jack ANT to connect the antenna
5
Mounting bracket
6
Mounting screw to fasten the antenna amplifier
2 Applications
The UB-900I is an antenna signal amplifier for
the receivers UF-…, US-… and IN-… which are
equipped with BNC antenna jacks The antenna
amplifier is designed to improve the interference
resistance and to increase the transmission range
Depending on the local conditions, it is possible
to double or triple the range In addition, the
UB-900I can compensate signal losses that occur
when a long antenna cable is used
For each receiver, two antenna amplifiers
are required which may be connected directly to
the receiver or via the antenna splitter UA-960
The receiver or the splitter connected to the jack
OUTPUT (2) will supply the amplifier with power
To increase the gain and thus the range, two
amplifiers UB-900I can be connected in series (see
fig below); the power supply will be internally
routed from the jack OUTPUT to the jack ANT (4)
English
