Molpir M-374, Installation Manual

Page: 32 / 40

Button 2: Disarm / Silent disarm / Remote Unlock / Siren stop
If system was triggered at armed state then siren chirps 4 times and car lights flash 4 times when
disarming.
Disarm the system
Press button 2 once, siren chirps twice, car lights flash twice, doors unlock, engine disable output is
deactivated (starter is enabled), LED is OFF or quickly flashes to indicate disarming status (depending
on function F6 setting).
When function F6 is activated then if door, hood or trunk is not opened or ignition is not turned ON within
30 seconds system rearms automatically and locks the door (LED quickly flashes and system arms).
Silent disarm
Press and hold button 2 for 1.5 second, car lights flash twice, doors unlock, engine disable output is
deactivated (starter is enabled), LED is OFF or quickly flashes to indicate disarming status (depending
on function F6 setting).
Unlock
While ignition is ON or in Valet mode press button 2 for remote unlock.
Refresh icons on remote control display
System (control unit) status check:
Press button 3 once, system (control unit) status information is sent to remote control (car lights do not
flash and siren does not chirp).
Trunk release
Press and hold button 3 for 1.5 second, trunk lock is released and car lights flash 4 times.
If you open trunk while system is armed, then trunk switch and sensors are bypassed and they are re-
activated 10 seconds after closing of the trunk.
Note: hood = (hood + trunk) are the same input wire to the system.
Car finding
Press button 4, siren chirps once and car lights flash 5 times to indicate position of the vehicle.
Panic mode
In any state of the system press simultaneously buttons 1 and 3 two times within 1 second to start Panic
mode - car lights flash and siren sounds 30 seconds, system is armed within this period of time.
Press button 1 or 2 to stop Panic mode.
Manual arming - arm without remote control
Within 5 seconds from ignition OFF press Valet switch and then press and hold valet switch (at least 3
seconds) until siren chirps once.
LED quickly flashes and system is armed 3 seconds after all doors, hood and trunk are closed.
Manual disarm
For manual disarm turn ignition ON and press valet switch within 5 seconds or input PIN code (according
to function F10 setting).
New remote controls codes storing (new remotes programming)
•
disarm, turn ignition ON and press valet switch 5 times within 10 seconds
•
siren sounds 1 long chirp indicating entering code learning mode
•
press simultaneously and hold buttons 1 and 2 until siren sounds long chirp indicating storing remote
control code into system storage. Maximum 4 remote controls codes can be programmed.