Molpir M-374, Installation Manual

Page: 33 / 40

•
turn ignition OFF or wait for 10 seconds while to leave code learning mode, siren chirps one short
and one long tone
Attention:
•
when learning new remote control all old ones will be erased from system memory
•
maximum 4 remote controls can be programmed (learned)
Valet mode ON
•
disarm the system, all doors, hood and trunk must be closed, switch ignition ON and OFF
•
within 5 seconds press valet switch once - LED lights permanently ON and system enters valet
mode
•
in valet mode LED lights permanently and alarm functions are limited to remote Lock/Unlock
•
in valet mode every ignition OFF will cause siren chirp once
Valet mode OFF
Necessary condition: system must be in valet mode and all doors must be closed
•
switch ignition ON and OFF
•
within 5 seconds press valet switch once - LED turns OFF and system leaves valet mode
2-stage shock sensor
Light shock will cause siren chirp 5 times and car lights flash 5 times for warning. Heavy shock (main
zone) will activate alarm with car lights flashing and siren sound for 30 seconds.
Anti-Hi Jacking
Active protection against vehicle thievery:
Necessary condition: ignition must be ON
•
press and hold buttons 1 and 3 until car lights flash 3 times and remote control display shows Anti Hi
Jacking icon
•
in the first step (within 20 seconds from Anti Hi Jacking activation) ignition OFF will cancel the timer,
ignition ON will resume timer
•
in the second step (20 seconds duration) siren shortly chirps and car lights flash. Even when ignition is
turned OFF siren continues to chirp and car lights continue to flash. When ignition is turned ON system
enters the third step immediately.
•
in the third step siren sounds permanently and lights flash for 20 seconds. Then system activates
circuits of engine and starter blocking. Ignition switch OFF will turn system to the fourth step
immediately.
•
in the fourth step siren sounds permanently and car lights flash till battery exhaustion or until Anti Hi
Jacking function is switched off
Stop Anti Hi Jacking function
In the first and second step - press valet switch once to exit Anti Hi Jacking function.
In the third and fourth step - turn ignition OFF and ON within 10 seconds and press valet switch or enter
PIN code to exit Anti Hi Jacking function.
Warning: power cut (car battery disconnection) and its reconnecting in any step of Anti Hi Jacking
function activation will turn system to the fourth step immediately - siren sounds permanently and car
lights flash till battery exhaustion or until Anti Hi Jacking function is switched off
System and Anti Hi Jacking function exit by PIN code (factory default of PIN code is „2 - 4“)
1. turn ignition ON and within 10 seconds press valet switch as many times as is value of the first digit
of PIN code and turn ignition OFF.
2. turn ignition ON and within 10 seconds press valet switch as many times as is value of the second
digit of PIN code and turn ignition OFF.
3. turn ignition ON, if inserted PIN code is valid siren chirps 3 times and system disarms.
Warning: when Anti Hi Jacking is in progress in the fourth step then remote control is not
functional and for exiting Anti Hi Jacking function you have to enter valid PIN code.
E
n
g
li
sh