Hand Crimp Tool for 1.25mm (.049") Pitch Wire-to-Board Crimp Terminal
Doc No: 638275000
Release Date: 04-27-15
UNCONTROLLED COPY
Page 6 of 7
Revision: B
Revision Date: 05-24-17
CAUTIONS:
1.
Manually powered hand tools are intended for low-volume use or field repair. This tool is
NOT
intended for
production use. Repetitive use of this tool should be avoided.
2.
Insulated rubber handles are not protection against electrical shock.
3.
Wear eye protection at all times.
4.
Use only the Molex terminals specified for crimping with this tool.
Certification
Molex does not certify or re-certify hand tools but rather supplies the following guidelines for customers to re-certify
hand tools:
%
This tool is qualified to pull force only. To re-certify, crimp a terminal to a wire that has been stripped 12.7mm
(.50”) long so that there is no crimping of the insulation. Pull the terminal and wire at a rate no faster than
25mm (1.00”) per minute. See the Molex website for the Quality Crimp Handbook for more information on pull
testing.
%
If the tool does not meet minimum pull force values, handle preload should be increased, and the pull test
should be rerun (see How to Adjust Preload).
%
When the hand tool is no longer capable of achieving minimum pull force, it should be taken out of service and
replaced.
