Tool Kit for 250 Slip-in Receptacle Terminals
Doc No: ATS-6382721HM Release Date: 12-13-13
UNCONTROLLED COPY
Page 4 of 8
Revision: A
Revision Date: 12-13-13
Figure 6
WIRE IN TERMINAL
JAWS
PARTIALLY
CLOSED
WIRE AGAINST
WIRE STOP
HANDLE
OPEN
LOCATOR
CLOSED
Figure 5
TERMINAL
PUSH HERE TO
OPEN WIRE STOP
5.
Return the locator to its original position.
6.
Turn the Locator Lock Latch up to lock. Make sure that
the terminal is visually centered over the punch.
7.
Insert the proper wire over the terminal.
8.
Gently touch the wire stop with the end of the wire.
See Figure 6 and 7.
9.
Compress the terminal by squeezing the tool handles
until the ratchet mechanism cycle has been completed.
Release handles to open the jaws.
10.
Remove the crimped terminal from the terminal locator
by pressing down on the wire stop and gently pulling
on the wire. The terminal locator can be in either
position.
11.
Visually inspect the crimped terminal for proper crimp
location.
Note
: The tamper proof ratchet action will not release the tool until it has been fully closed.
For the Battery Power Tool:
1.
Cycle the Battery Power Tool to crimp the terminal to the wire.
2.
Remove the crimped terminal from the terminal locator by pressing down on the wire stop and gently pulling on
the wire. The terminal locator can be in either position.
3.
Visually inspect the crimped terminal for proper crimp location.
Maintenance
It is recommended that each operator of the tool be made aware of, and responsible for, the following maintenance
steps:
1.
Remove dust, moisture and other contaminants with a clean brush, or soft, lint-free cloth.
2.
Do not use any abrasive materials that could damage the tool.
Figure 7
WIRE
INSULATION
PUNCH
CONDUCTOR
ANVIL
LOCATOR
INSULATION
ANVIL
WIRES AGAINST
LOCATOR STOP
CONDUCTOR
PUNCH
TERMINAL
