
6
Chapter 2. Connections and controls
2.2
Rear panel controls and connections
+9-30V
PID
TRIG
FSW
Figure 2.4:
MOGLabs
FZW
Rev4 rear panel layout.
From left to right, the features of the rear panel (Figure 2.4) are:
Power switch
Switches the unit on/off.
DC supply
2.1mm centre-positive barrel-jack connector for supplying power the
unit.
Not required if power is supplied over USB. Use of a floating
(unearthed) plugpack power supply is not recommended.
Use +5 V
for Rev1 to Rev3; +9 to +30 V for Rev4 devices.
USB
Standard USB type-B connector for powering and/or communicating
with the device. When used to power the device, must be connected
to a USB port capable of supplying 600 mA.
Ethernet
RJ-45
jack
for
10/100
MB/s
TCP/IP
communications,
which
is
the
recommended interface for computer control and monitoring.
PID
Analogue output port for wavelength monitoring or PID control of
laser
wavelength
(see
16-bit
resolution
with
±
2
.
5 V
output range.
TRIG
Active-low TTL input for synchronising the wavemeter measurement
to an external trigger (see §4.5).
FSW
M8 connector for interfacing with the
FSW4
/
FSW8
multi-channel op-
tical switcher (see chapter 6).
Summary of Contents for FSW4
