Moeller ps4-201-mm1, Hardware And Engineering

Page: 67 / 94

Starting the PLC with a
program stored in
the memory module
63
04/
99 AW
B
27-
1184 G
B
Starting the PLC with a
program stored in
the memory module The procedure for starting a user program in the
memory module is as follows:
왘
Plug the memory module into the PLC (the PLC
must be switched off). The setting of the operate
mode selector switch is not important.
왘
Switch on the PLC. The program in the memory
module is then copied to the PS4-200 and the
PLC is started up according to the configured
startup conditions.
Programming via
Suconet K It is possible to program several networked stations
and to run test and startup functions from a single
programming device attached to Sucone tK without
having to connect a programming cable to each of
the stations in turn. This method can be used for all
stations which are connected to the line served
directly by the master PLC. If one of these stations
(e.g. LE4-501-BS1) opens another line, you will not
be able to access the stations connected to it (see
broken line in figure below). For further information
on this topic refer to the manual “Sucosoft S 40 User
Interface” (AWB2700-1305GB, chapter 8).