42
Form the two (2)
Plywood Step Plates
using hot water soaking and slowly form with fingers to match
to rib locations onto
Rib WR1
and
WR2
and once the shape is maintained dry then set aside to be
glued in place later. Add the twelve (12)
Rib Tabs WR6
and
WR6a
(1) making sure that they are
spaced about 1/32” from the outer edge of the
Trailing Edge
as seen on the
Building Pattern
. Apply
Wood Conditioner to the entire wing to stabilize the laser cut char prior to painting. Allow the
Wood
Conditioner
to dry completely before painting with
Deck House Light (MS4821).
Right Wing Difference:
The only difference
the right has is the addition of the
Compass.
Once the
right wing is assembled and sanded place on the building pattern mark the location of the
Compass
on
the edge of the
Caps
and glue in place the
Compass Holder
with the circle cut out to the underside of
the
Caps
between the
Ribs
. On the forward edge glue the vertical
Brace
. See the picture on the next
page. Then glue the two (2)
Triangular Braces
to the top surface and then glue them to the underside
of the
Cap
against the
Rib
wall aligning it with the front edge of the
Compass Holder
. Now apply
Wood Conditioner and paint
Deck House Light (MS4821)
per the left wing. Once the right wing is dry;
glue the
Compass
in place in the
Compass Holder
. The compass label and lense should be done
prior to gluing in place.
