27
/40
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [email protected]
4.
Insert the housing and circuit board into the socket:
The two cable clamps on the rear of the housing are
located at the top. When using a cavity socket (item
1.9), make sure you only use the stainless steel screws
provided (item 1.6). Other (larger) screws could damage
the circuit board.
5.
Attach the frame:
Place the selected frame (item 1.3,
concave, convex or fl at) onto the circuit board and press
down gently until it automatically snaps into place.
MOBOTIX is printed on the bottom of the frame.
6.
Insert the panel:
Hook the front panel onto the frame,
as shown in the fi gure, and then press it down.
7.
Screw the panel on tightly:
Secure the front panel
using the panel's stainless steel screw. Continue with
Section 3 (Operation).
The circuit board is
attached directly to
the socket using two
screws (item 1.4.) (see
left) or it is attached to
the wall using the Torx
screws (see page 22)
First attach the panel below,
then hook it on above
MOBOTIX printed
at the bottom
