Mobotix MX-Q26B-6D016, Manual, Page: 124 / 148

124
Q26 Camera Manual: Operating the Camera
3.3.3 Special Q26 Configuration in the Browser
Thanks to its hemispherical lens, the MOBOTIX Q26 provides certain special configuration
options for the image settings. Depending on where the camera is mounted (ceiling or wall)
and on the live image display preferred by the user, certain important basic settings and, if
necessary, their adjustment must be configured when a Q26 is first installed.
A corresponding adjustment of the image setting is strongly recommended if the on-wall set
is mounted with an inclination of 10 degrees (available as a Q26 accessory).
Configuration of the Q26 Basic Parameters
Complete the steps described below in the browser window:
1. Log onto the camera and boot it as described in Section 3.2.
2. Select mounting position wall/ceiling/floor : Click on Installation in the Quick Control
panel and then select
Wall, Ceiling or Floor
according to the mounting position of the
camera. Ceiling always means that the orientation of the camera or sensor module
is from top to bottom and for Floor , the camera or sensor module’s orientation is
from bottom to top.
As a result, you will get a
perspective-corrected panorama view
for each image sensor
matching the specified mounting position. Panorama view is set as a factory default
and it can be changed as described below.
3. Switch to the Display Mode Quick Control.
4. Set the mode that you want to be the standard view. For demonstration purposes,
the descriptions below describe the typical display mode for the wall mount and the
ceiling mount,
Panorama and Surround respectively. Every other display mode can
be operated in the same way.