Mobius M9 SORTER, User Manual, Page: 26 / 30

MOBIUS CONVEYOR USER GUIDE
26
© 2 0 2 1 E T E R O S T E C H N O L O G I E S I N C . A L L R I G H T S R E S E R V E D . | M O B I U S T R I M M E R . C O M
6. Using a 5/32 hex key, remove the 4 screws securing the plate to the two side arms.
7. With the plate removed, separate the arm with the problematic bearing. Remove the old bearing,
and replace it with your new one. Then reinstall the plate you removed in the previous step.
8. Slide the motor assembly back into the conveyor body, and secure it with the 4 screws that were
removed earlier. Note that there are 3 sets of holes on the side arms. We recommend that you
install the screws through the middle set of holes.
9. Re-install the motor by sliding it on to the drive shaft. Ensure that the motor is in the orientation as
shown, and that the keyway bore on the motor aligns with the key in the shaft. Secure the motor
with the 4 bolts removed earlier.
10. Reinstall the belt and side panels.