i-Sat
Mounting and usage instructions
Page 12 of 12
7.7.3.
Clear alarm condition
When an alarm is detected, it’s possible to clear the alarm condition pressing the ON/OFF key
for more than 3 seconds but less than 6 seconds.
ATTENTION
If the ON/OFF key is pressed for more than 6 seconds the whole system will be reset
The functions activated by the clear alarm procedure are:
Alarm Action performed
1, 2, 3 The electronics will be reset and the antenna will act as the first power on; the first
operation will be dish closing. If the error is detected again, the alarm condition will be
activated again
4, 5, 6 The system passes in “Satellite selection” state
7
Dish closing continues
7.8. System Reset
Except of standby state, in all the remaining states it is possible to reset the whole system
pressing the ON/OFF key form more than 6 seconds. In this case the antenna is reset as the
first power on and the first operation will be the dish closing. In the following table are described
the reset operations.
ON/OFF
key
pressed
LED ON/OFF
State
1…3Sec
Red led blinking every 0,25
sec. Green led maintains its
state
Reset activation time is > 3 Sec.
ON/OFF key release reset only the alarm condition.
3…6 Sec
Red led blinking every 0,1 S
sec. Green led switched off
Reset activation time is < 3 Sec.
ON/OFF key release reset only the alarm condition.
> 6 Sec.
Red led steady on
Whole system reset
8. References
Mobiltech s.a.s.
Via Brughetti, 9/E
20030 Bovisio Masciago (MI)
Tel: (+39) 0362 – 544.928
Fax: (+39) 0362 – 576.478
Internet:
www.mobiltech.it
Mailto:
