i-Sat
Mounting and usage instructions
Page 9 of 12
6.2. Mounting on a mobile position
Execute the following steps:
-
Position the antenna and the fixing plate on a plain surface, free of obstacles in the
satellite direction. For an outdoor usage is available a specific optional tripod.
-
Connect the 4mt 75Ohm satellite cable, supplied with the system, using the 11mm key.
-
Connect the output of the remote control to the satellite receiver.
-
Connect the power supply cable (12V or 24V) to the remote control.
Now the system is ready to be used.
7. Usage instructions
7.1. General notes
When the system is powered the antenna, if
opened, will be closed automatically.
When the system is powered the led under the
ON/OFF key will flash green every 4 seconds.
This means that the system is ready to be used.
In the figure is displayed the system remote
control.
7.2. Power on
To switch on the system press the ON/OFF key. The led under the key and the one related to
the last selected satellite will become steady green.
In case the led under the ON/OFF key will become red, see the reported errors table at page 11
and execute the related instructions.
7.3. Satellite selection and search
To select another satellite press quickly the SAT key. The selected satellite is displayed by the
related green LED.
To activate the Satellite search press the SAT key for 3 seconds. During the search phase the
related satellite led flashes red; if the satellite is found the led becomes steady green. If the
system is not able to found the satellite signal the satellite led will become steady red. To stop
the search function at any time press the SAT key.
