
Mobilex A/S
Grønlandsvej 5
DK-8660 Skanderborg
www.mobilex.dk
Pump
•
DO NOT immerse or soak the pump.
•
Check for external damage and move the pump to a cleaning area.
•
Place the pump on a work surface and spray or wipe the outside of the case with quaternary
ammonium solution.
•
DO NOT spray any cleaning solution directly on the surface of the pump.
•
DO NOT use a Hypocarbonate or Phenolic based cleaning solution as this may cause damage to
the case. Allow the solution to incubate for 10 minutes or accordingly as stated by the cleaning
product used.
•
Spray cloth with cleaning solution and clean faceplate. DO NOT allow excess cleaning solution on
faceplate or control panel (if solution gets inside, damage will occur).
•
Allow surface to thoroughly dry after cleaning.
•
After the pump is thoroughly cleaned and dried, proceed to plug in the pump and test to see if it
runs normally.
Bubble pad
•
Any obvious blood spots should be wet thoroughly with 1:9 Hypochlorite solution
•
(1 part bleach to 9 parts water) and allow drying for at least 10 minutes. Then use a clean, damp
cloth.
•
Brush or wipe down all surfaces with soap and water before applying any liquid.
•
Allow it to thoroughly air dry. Once the inside is dry, turn it back: wipe down the outside of the bag
with disinfectant.
•
Dry the bubble pad on a sunless area after cleaning.
Maintenance
•
Check the power cord and plug to see if there are abrasions or excessive wear.
•
Plug in the pump and check the airflow from the hose connection port. The airflow should alternate
between ports every half-cycle time.
•
For storage lay the bubble pad flatly. Fold or roll it carefully. Unplug the pump and store with proper
identification tag. Store device in dry places with non freezing temperatures.
Disposal of the product
The product cannot be disposed of with household waste but must be brought to the local
recycling centre. Follow the national requirement to dispose the pump. It should be delivered to
the deposit station for re-use or recycling.
Most common problems and solutions
Problems
Solutions
The pump
doesn’t work
1. Check if the plug is inserted firmly into the outlet.
2. Turn on the power switch again.
3. If the power indicator is ON and the pump still doesn’t work, contact your local
dealer immediately.
4. If the power indicator is OFF, there may be a faulty outlet. Try to connect the power
cord to another outlet. If the power indicator is still OFF, contact a qualified
electrician for main power check.
Incomplete inflation
(Low pressure)
1. For a quick check, adjust the pressure to Firm.
2. Check to see if the inflation tubes connected to the pump are twisted or
disconnected, or any leakage occurring. Always keep the tubes straight. Change
the tubes if there is any leakage.
Rev. 10.2018
page 4 of 16
UM-270016-Multi.odt
a better life in motion