MobileView PENTA, Installation Manual

Page: 17 / 114

Chapter 2: Camera installation
MobileView PENTA Installation Manual 11
Figure 4: Mounting holes
1. Cable entry hole
2. Mounting hole
3. Mounting hole slot
To surface mount a camera housing:
1. Use the template in Figure 64 on page 102 to mark the location of the cable-
entry hole and two mounting holes (see Figure 4 above).
2. Using a 3/16 in. (5 mm) drill bit, drill the two mounting holes.
3. Using a 1 in. (25 mm) drill bit, drill the cable entry hole.
4. Install a 3/4 in. (20 mm) (interior diameter) grommet on the cable entry hole,
or where feasible.
5. Connect the video and power cables to the camera, and then feed the excess
cable into the vehicle’s duct area.
6. Mount the camera and mounting plate onto the vehicle surface and tapping
plate, if used. Do not put the screw in the center of the mounting hole slot
(Figure 5).
7.
To align the camera’s field of view, see “Adjusting the camera’s field of view”
on page 13.
8. Use a thread-locking compound, which prevents screws from vibrating, to
secure the surface-mount housing to the mounting plate with the four 3/8 in.
tamper-resistant tamper-torque machine screws (Figure 6).