MobileView 7000 Series, User Manual

Page: 17 / 67

MobileView 7000 Series User Manual
9
when the recorder is secured to a stationary (with respect to the vehicle), vibration-resistant,
horizontal surface. Mounting the recorder in a way that does not meet these requirements
may result in undesired performance.
To mount the recorder:
1. On a flat, stationary, and vibration-resistant surface, use the recorder base as a template
to mark and drill four mounting holes.
2. Using bolts, locking washers, and nuts, mount the recorder base plate to the vehicle
surface.
Mounting the recorder
1. Mounting bolts
2. Main housing
To resist vibration, use nuts with a thread locking compound or a self-locking nylon insert.
Failure to use such devices may result in insecure mounting and damage to the unit.
Tools and Materials
The list of tools and materials below is recommended for installation. This list is not
complete and the installation may require different or specialty items.

BNC crimper

Cat 5 ethernet crossover cable

Cat 5 ethernet patch cable

Drill and bits, up to 5/8 in.

Electrical connections (ends, lugs,
etc.)

Electrical tape

Electrical voltmeter

Extension cords

General tools

Heat shrink

Hole saws, up to 1–1/8 in.

Laptop/viewing station

Thread-locking compound

Molex pin crimper

Phillips and flathead screwdrivers

Riv-nut gun

Socket set, up to 5/8 in.

Solder gun with solder

Spare BNCs

Wrenches, up to 5/8 in.

Spare Molex pins

Spare terminal blocks

Tie wraps (8 in.)

Torx bit, secured #10

Wire snake

Wire strippers