Mobeye CM-Guard TwinLog CML2055, User Manual

Page: 11 / 40

10
When using your own SIM card:
Before installing the SIM card should have PIN code "0000", or PIN code removed.
(A PIN code can be changed or removed by putting the SIM card in to any mobile phone and
entering the 'security' menu.)
NB: Make sure the SIM card is inserted before the batteries. If you replace a SIM
card, first remove the batteries (and remove any other external power supply). The
settings are stored in the device memory. The SIM card shall have the
“normal” size
and be suitable for 2G. It is advised to use an M2M SIM card.
3.2 INSERT THE BATTERIES
Insert the two batteries (CR123) in the module. Use the +/- indication for the correct
placement. If you replace the batteries the settings will not be deleted, since they are
stored in the device memory.
3.3 CONNECT THE TEMPERATURE SENSOR
Plug the external temperature sensor into the
socket and press it firmly. It is possible to connect
two temperature sensors.
3.4 CONNECT AN EXTERNAL POWER SUPPLY (OPTIONALLY)
Although the Mobeye CML2255 is designed to run on batteries, it is possible to use
an external power supply. In this mode the module is always connected with the
GSM network and therefore always in program mode. When the power fails, the
batteries take over and a power failure alarm message is sent. The module
continues operating albeit in the low power mode. This means the GSM module
switches off and only establishes network connection when it needs to send an
alarm notification, test message or low battery alert.
sensor 1
sensor 2