MMP SA-2550A
Page 10 of
24
Midwest Motion Products
DESIGN, MANUFACTURING & DISTRIBUTION - MOTION CONTROL EQUIPMENT
email:
If an external command signal (usually 10 VDC) is used in place of a potentiometer then wire as shown below. Remove connection to
P1-1 and connect the signal positive to pin 5 (for %0-%100 POT effect). Ensure VCOM is grounded to P1-2.
Figure 2. Encoder feedback with external command.
For further details on configuring the command signal curve, please consult the answer to question 3 in the troubleshooting guide,
found on page 22.
MIDWEST M
O
TION
P
RODUCTS
