INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following product:
TPR14LED
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this product when deciding the location for
installation
•
This product is Class II double insulated
•
This product is IP65 rated
INSTALLATION
Note - If this product is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with LED luminaires.
•
Provide power to the required point of installation (refer to BS7671 for correct cabling methods).
Suitable IP rated junction boxes should be used where required
•
Remove the diffuser by unfastening the three screws on the front
•
Open the hinged LED plate by releasing the tab labelled “OPEN” (see Fig. 1)
Fig. 1
•
Drill the fixing holes in the rear of the fitting. Mark the location of the fixing holes and drill ensuring not
to infringe with any gas/water pipes or electrical cables
•
Feed the mains cable through the rubber grommet to retain IP rating, or alternatively, drill out one of
the two 20mm drilling guides on the sides of the fitting (see Fig. 2)
Fig. 2
•
Secure the baseplate to the surface using the fixings provided
•
Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown),
N - Neutral (blue)
•
Close the hinged gear tray until the tab clicks into position
INSTALLATION
Note - Microwave sensors may not be suitable for all installations, for example enclosed
spaces, as they are able to detect movement through non-metallic surfaces like
plasterboard and thin doors.
• Provide power to the required point of installation (refer to BS7671 for correct cabling
methods). Suitable IP rated junction boxes should be used where required
• Remove the diffuser by unfastening the three screws on the front
• Open the hinged LED plate by releasing the tab labelled “OPEN” (see Fig. 1)
• Drill the fixing holes in the rear of the fitting. Mark the location of the fixing holes and drill
ensuring not to infringe with any gas/water pipes or electrical cables
• Feed the mains cable through the rubber grommet to retain IP rating, or alternatively, drill
out one of the two 20mm drilling guides on the sides of the fitting (see Fig. 2)
Fig. 1
