Chapter Two: Installation
How To Unpack the 1100 Series Unit
9
Chapter Two: Installation
How To Unpack the 1100 Series Unit
MKS has carefully packed the Type 1100 Series unit so that it will reach you in perfect operating
order. Upon receiving the unit, however, you should check for defects, cracks, broken
connectors, etc., to be certain that damage has not occurred during shipment.
Note
Do not discard any packing materials until you have completed your
inspection and are sure the unit arrived safely.
If you find any damage, notify your carrier and MKS immediately. If it is necessary to return the
unit to MKS, obtain an ERA Number (Equipment Return Authorization Number) from the MKS
Service Center before shipping. Please refer to the inside of the back cover of this manual for a
list of MKS Calibration and Service Centers.
Unpacking Checklist
Standard Equipment:
•
Type 1100 Series MFC unit (Refer to Introduction, page 5, for a description of the units
included in this series.)
Optional Equipment:
•
Power Supply/Readout device
•
Cabling to connect the flow controller to the readout device
(refer to Interface Connectors and Cables, page 20)
CB259-5-10
Connects the 1159/2159 and 1162/2162 units to
Type 246 and247 readouts
CB147-1-10
Connects the 1159/2159 and 1162/2162 units to
Type 167 and 647 readouts
CB259-10-10
Connects the 1160/2160 and 1163/2163 units to
Type 246 and 247 readouts
CB147-7-10
Connects the 1160/2160 and 1163/2163 units to
Type 167 and 647 readouts
Note
In order for the 1100 Series MFC to comply with CE Mark specifications
you must use a metal braided, shielded cable.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com