MKS Baratron 127A, Instruction Manual, Page: 18 / 38

Interface Cables Chapter Two: Installation
10
Interface Cables
As of January 1, 1996, most products shipped to the European Community must comply with the
EMC Directive 89/336/EEC, which covers radio frequency emissions and immunity tests. In
addition, as of January 1, 1997, some products shipped to the European Community must also
comply with the Product Safety Directive 92/59/EEC and Low Voltage Directive 73/23/EEC,
which cover general safety practices for design and workmanship. MKS products that meet
these requirements are identified by application of the CE Mark.
To ensure compliance with EMC Directive 89/336/EEC, an overall metal braided shielded cable,
properly grounded at both ends, is required during use. No additional installation requirements
are necessary to ensure compliance with Directives 92/59/EEC and 73/23/EEC.
MKS offers a full line of cables for all MKS equipment.
Note
1. An overall metal braided shielded cable, properly grounded at both
ends, is required during use to meet CE specifications.
2. To order a metal braided shielded cable, add an “S” after the cable
type designation. For example, to order a cable to connect a 127 unit
to a PDR-C unit, order CB127S-1 for an overall metal braided
shielded cable; order CB127-1 for a non-shielded cable.
Interface Cables
To Connect To A . . . Use Cable . . .
PDR-C-1C/2C, PDR-5B CB127S-1-XX; CB127-1-XX
244, 250, 252, 152 260 Series CB258S-1-XX; CB258-1-XX
146, 186, 651, 652, 660 CB259S-5-XX; CB259-5-XX
where XX indicates the cable length