28
HD-101r
SeTUp
If using a portable generator, ensure the generator meets the following minimum requirements:
5 KW
120/240 volts
41.7/20.8 amps
Single Phase
This saw is to be used with a Ground Fault Circuit Interrupter.
When loosing the Cutting Head Adjusting Knob, the Cutting Head will pivot
down unless held.
(A)
Ensure the ON/OFF Switch
is in the OFF position
(B)
Plug HD-101R into the GFCI
(C)
Plug the GFCI into the
Power source *
VolTaGe
120V
CYCle
60hz
pHaSe
1-phase
CaUTion
4. If using an extension power cord, made sure, the length and wire gauge
correspond to the requirements listed in the table on page 10. An extension
power cord that is too small in wire gauge (diameter), or too long in length, will
cause the motor to overheat and could cause premature failure.
noTe: In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
porTaBle GeneraTor
GroUnD FaUlT CirCUiT inTerrUpTer (GFCi)
SeT CUTTinG DepTH
5. Use an approved Ground Fault Circuit Interrupter (GFCI)
6. Do not cover the motor vents as this could lead to motor overheating.
(A)
Loosen Cutting Head Knob and
move cutting head down
(B)
Set cutting depth approximately
1/4 to 1/2 inch below the surface
of the Movable Cutting Table
(C)
Ensure the Adjusting Knob is
tight
