BEAM SPOT WASH (3IN1) 350W
BEAM SPOT WASH (3IN1) 350W
Operation Menu:
Menu Structure chart:
Main interface --Set up ----Running mode
----DMX address
----Channel mode
----X Reversal
----Y Reversal
----Y Reversal
---- XY Encoder
----No DMX signal
----screen protector
----Boot bright bubble
----Color wheel linear change
----Restore the default settings
--Manual
--system ----Software version
----DMX Channel value monitoring
----System error record
-----Total use time
-----This time of use
----The total time of the bright bubble
----This time the bubble time
--advanced ----Reset calibration
----Maximum bright time
----The bright bubble time is cleared
----Sensor monitoring
--Switch between Chinese and English
--The screen rotates
6
Advanced
Set a password here to prevent misuse of non-professionals. The default password is "up and
down". Press "OK" to verify the password.
Option
Description
Reset calibration
After entering the sub-interface, you can adjust the X-axis, Y-axis and
other motor reset position to compensate for the hardware installation
of the error, the adjustment range -128 ~ +127, + 0 that no adjustment.
Maximum bright
time
0-9999 hours, the operation of the maximum bright bubble time the
system will have alarm tips
The bright bubble
time is cleared
After clearing, the light bubble time is recalculated
Sensor
monitoring
Real-time monitoring lights on a variety of photoelectric switches,
Hall and other sensor status
Maintenance:
To prolong the life of the projector, some maintenance work has to be done to
ensure the optical system in good condition. If the projector does not function, check
the fuses on the power socket of the projector, they should only be replaced by
fuses of the same specification. Should these be damaged, call a qualified
technician before replacement. The projector has thermal protection device that will
switch off the projector in case of overheating. Should either of these operate, check
that the fans are not blocked, and if they are dirty, clean them before switching on
the projector again. Check that the fans are operational, if not, call a qualified
technician.
☆
Any maintenance work should only be carried out by qualified
technicians.
Keeping The Product Clean:
To ensure the reliability of the projector, it should be kept clean. It is recommended
that the fans should be cleaned every 15 days. The lens and dichroic colour filters
should also be regularly cleaned to maintain an optimum light output.
Do NOT use any type of solvent on dichroic colour filters.
Cleaning frequency depends on the environment in which the fixture operates: damp,
smoke or particularly dirty surroundings can cause greater accumulation of dirt on the
unit's optics. A soft cloth and typical glass cleaning products should be used for
cleaning. It is recommended to clean the external optics at least once every 15 days
and clean the internal optics at least once every 60 / 90 days.
☆
Do not use any organic solvent, e.g. alcohol, to clean housing of the
apparatus.
9
Summary of Contents for MJ-1350N
Page 2: ......
