MJ LED LIGHTNING MJ-1350N, User Manual

Page: 6 / 10

BEAM SPOT WASH (3IN1) 350W BEAM SPOT WASH (3IN1) 350W
.Lamp work will reach a very high temperature, Vapor discharge lamp can not
continue to supply this physical characteristics, therefore, the power completely cool
for 10 minutes before on the operation. Failure to do so will lead to a high-pressure
discharge and short circuit burned out the computer's control panel components.
Notes:
Unplug the light from power before lamp installation or replacement
and wait for it to cool.
Power Code Connection:
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Use the plug provided to connect the mains power to the projector paying attention to
the voltage and frequency marked on the panel of the projector. It is recommended
that each projector be supplied separately so that they may be individually switched
on and off.
★
It is essential that each projector is correctly earthed and the
electrical installation conforms to all relevant standards.
DMX Connection:
Connection between the controller and a projector and between one projector and
another must be made with a 2 core-screened cable, with each core having at least a
0.5mm diameter. Connection to and from the projector is via cannon 3 pin (which are
included with the projector) XLR plugs and sockets. The XLR's are connected as
shown in the figure above.
3
70-74 CWhite light
75-79 CColour13
80-84 CColour12
85-89 CColour11
90-04 Colour10
95-99 Colour9
100-104 Colour8
105-109 Colour7
110-114 Colour6
115-119 Colour5
120-124 Colour4
125-129 Colour3
130-134 Colour2
135-139 White light+Colour1
140 Slow water
…… ……
255 Fast water
CH10 Rotating Gobo
0-9 White light
10-19 pattern1
20-29 pattern2
30-39 pattern3
40-49 pattern4
50-59 pattern5
60-69 pattern6
70-79 pattern7
80-89 pattern8
90-99 pattern9
100 Fast rotation
…… ……
175 Slow rotation
176 Slow rotation
…… ……
255 Fast rotation
12