MJ LED LIGHTNING MJ-1350N, User Manual

Page: 5 / 10

BEAM SPOT WASH (3IN1) 350W BEAM SPOT WASH (3IN1) 350W
Install The Equipment:
Use 2pcs clamp and 1safety cord(need to purchase).Use clamp fix with light hook
which in the packing box with light, then use screw install to the bottom of lamp. Hang
the fixture on the structure and fasten the screws attached to each clamp. Make sure
the light is installed reliable, and confirm the light which you fixed is strong enough for
hanging the light. Base on safety reason, please according to the above picture using
safety wire cross the light to make it strong enough again.
Warning!
1. Unlock the PAN and TILT before the 1st application of the light for safety.
2
．
Hook and clamp only use for hanging the light. Do not use clamp as a tool to move
fixtures.
3
．
Base on safety reason, please use the safety cord which can afford the weight ten
times of lamp through Insurance hole for auxiliary hanging.
4
．
Don't use the handle of the moving head light to fixed or lift!
Fitting The Lamp
：
.Loosen 4 fast-fit screws and remove the back cover, when fitting/replacing the lamp.
.Do not touch the bulb of the new lamp with bare hand so as not to influence the beam
output.
.Do not harm the sticking out point of the lamp during its installation.
.Fit new lamp and close the back cover by fastening 4 fast-fit screws when finished
lamp installation.
2
CH11 Gobo rotation 0-126 Angle adjustment
127 Fast rotation
…… ……
190 Slow rotation
191-192 stop
193 Slow rotation
…… ……
255 Fast rotation
CH12 Pattern shake 0 stop
1 Moving slowly shake
…… ……
255 Moving fast shake
CH13 Fix Gobo + shake
0-4 White light
5-9 Pattern 1
10-14 Pattern 2
15-19 Pattern 3
20-24 Pattern 4
25-29 Pattern 5
30-34 Pattern 6
35-39 Pattern 7
40-44 Pattern 8
45-49 Pattern 9
50-54 Pattern 10
55-59 Pattern 11
60-64 Pattern 12
65-74 Pattern 13
75-129 Fast rotation from fast to slow
130-134 Rotation stops from slow to fast
14