Mitutoyo DP-1VA LOGGER, User Manual

Page: 39 / 99

23
2 Basic Operations
No. 99MAM029A
Tips
The tolerance judgment result can be output by connecting the GO±NG judgment cable
(option) to the output connector.
For further details on the tolerance judgment result output function, refer to "4.3 Toler-
ance Judgment Result Output" on page 58.
Based on the measurement data here, "2.4 Printing the Statistical Calculation Value" on
page 24 is performed.
2.3.3 Deletion of Upper/Lower Specifi cation Limit Value
(Limit Data)
When deleting the upper/lower specifi cation limit value (limit data), follow the procedure
below.
1
Enter the limit input mode.
1
Press
TOL.
REC/STOP
.
2
Select the limit data.
Tips
If the limit data desired to delete is printed with the operation in procedure 1 , this opera-
tion is not required. Proceed to procedure 3 .
1
Continue to press
STAT.
OUT LOG
until the limit
data desired to delete is printed.
» The limit data is switched each time
STAT.
OUT LOG
is pressed.
Tips
The old data is overwritten and disappears if the new limit data is input to it by selecting
the limit data number already set.
3
Delete the limit data.
1
Press
CLEAR
.
Tips
The measurement data can be immediately input following the operation above. However,
the tolerance judgment cannot be performed as the limit data is deleted. To perform the
tolerance judgment, enter the limit input mode again and measure after selecting the limit
data set for the tolerance judgment.
POWER
TOL.
REC/STOP
PRINTER CLEAR
STAT.
OUT LOG
CANCEL
DATA FEED