Mitsubishi SRK19CNS-S, Technical Manual

Page: 25 / 70

- -
'14•SRK-T-164
– 34 –
1. Remove the drain hose. 2. Remove the drain cap. 3. Insert the drain cap. 4. Connect the drain hose.
•
Remove the screw and
drain hose, making it
rotate.
•
Remove it with hand
or pliers.
•
Insert the drain cap which was removed at
procedure “2” securely using a hexagonal
wrench etc.
Note: Be careful that If it is not Inserted
securely, water leakage may occur.
•
Insert the drain hose securely,
making rotate. And install the
screw.
Note: Be careful that If it is
not Inserted securely, water
leakage may occur.
[Drain hose changing procedures]
•
Do not place the power supply cords above the gutter,
because the air conditioner is structured in a way where
condensation on the back side is collected in to the drain
pan before drainage.
•
Do not make traps in the drain hose line.
Wall
Gutter
Pipes storage area
Declining slope
Inverted slipe
Trap
Installing steps
1.Hook the upper part
of the indoor unit to
the installation board.
2.The unit can be installed
simply by gently push-
ing in the lower part.
5
Securing the indoor unit to the installation board
Wall
Indoor unit base latch
Installation board
Latch (2 locations)
Installation board
Indoor unit
•
How to remove the indoor unit from the installation board
1
Push up at the marked portion of the indoor unit base
lower latch, and slightly pull it toward you.
(both right and left hand sides)
(The indoor unit base lower latch can be removed from
the installation board)
2
Push up the indoor unit upward. So the indoor unit
will be removed from the installation board.
The marked portion of the
Indoor unit bese lower latch
RMA012A076A_En.indb 34 22-Jan-14 09:00:40