Mitsubishi PLK-E Series, Technical Manual

Page: 181 / 213

Function mode
(2) Explanation of each function mode
Copy mode
The stitching data is copied "from the internal memory to a floppy disk" or "from a
floppy disk to the internal memory".
[Memo] Sewing data will be copied in the overwriting mode. For this reason, if the
sewing data having the same data number is in the internal memory or
floppy disk, the new sewing data will be overwritten on the old sewing data.
Select the copying direction in the same way as the data reading/writing operation.
(Check the picture of the key shown at the upper left section of the screen.)
Select the data you would like to copy by pressing the corresponding numeric key
(maximum 10). After that, press to copy the data.
(To select all the data, press .)
From internal memory to floppy disk
Memo The number of the data in which the floppy
disk can be written in the maximum is 224
patterns
and for the internal memory can be
written in the maximum is 255 patterns.
Please note that all data cannot be copied as
the case. ( For that case, the message is
displayed.)
From floppy disk to internal memory
Needle DOWN angle setting
The needle position angle for the needle UP/DOWN key is set here.
U8 setting: Needle UP position stop setting
D8 setting: Needle DOWN position stop setting
R8 setting: Reverse run angle setting
[Memo] Refer to Program mode [Needle Position]
for details on these settings.
Be careful! Pressing the key will
lift or lower the needle.